Announce: Star Rollover LED boards

We are pleased to make a delayed announcement of a product which we’ve had in stock for almost a year. This Star Rollover LED board fits on the underside of your Playfield under a Star rollover assembly and will bathe the Star Insert is lower power LED light. With this product you can replace the inefficient horizontal lamp socket and incandescent light bulb with this board:
Star Rollover
Each board provides 4 natural white LEDs in a non-polarized light from either a 6.3V source. Because the board has a built-in rectifier bridge; you can supply power from both a 6.3VAC GI circuit or ~6.3VDC controlled insert. You can even control the brightness via a microcontroller PWM signal or from one of the new DIY control systems such as the PROC or its PD-LED driver board.

The design also features a brightness resistor at R5 to allow you to dial the brightness to your desired level. A hole in the center of our PCB allows the actuator to work from the insert to a standard Leaf switch typically under the insert.

A typical installation may require a set of #6-32 x 0.25 inch wood screws so you can bolt it to the back of the playfield under the star rollover insert. Electrical installation is super simple; simply solder the GI connection from the old horizontal lamp socket to the JGI connection, or jump to the nearest GI socket as we did in our machine below. Here is an example installation we did on our Star Trek: The Mirror Universe custom pinball machine.


Source: My Star Trek: The Mirror Universe custom machine

This populated PCB is available for immediate shipping in Our Online store @ http://pinball-mods.com/oscom/modifications-do-it-yourself-star-rollover-led-p-17.html