Previous work on this Cabinet: part 1 and 2
Now my attention turns to the stenciling of the side cabinet. First color… yellow:
Once the yellow dried overnight; I pulled the stencil up:
Yeap; that’s right… The use of the waterslide decal came back and bit me in the butt. The stencil pulled the toner right off label.
:sigh:
After many choice explicatives; I decided there wasn’t much I could do now… so I went ahead and continued stenciling the grey; opting to see what (if anything) the Enterprise would cover. Ofcourse; I designed the decal location to be where the Klingons were; so I knew it wouldn’t cover jack… but it made me feel better. I also figured if the next stencil pulled up more; I could fix it once and be done.
Down goes the Enterprise stencil..
This time I left the protective backing on the section which went over the waterslide decal.
I sprayed the grey primer and let it dry overnight. The backing protect the label; so I proceeded to cover the paper areas with the black stain to match the color of the cabinet. I then re-airbrushed to blend the new black with the background image. I then re-sprayed the holographic flake and clear coat as best I could with airbrush.
Good as new? no. but, not too bad I guess.
Now for the orange stencil.
The orange wasn’t Red enough for my Nacelles… so I sprayed them with cherry red.
And finally; the blue phasers:
Ofcourse; the blue phasers crossed over the nebula – I had to use some of the stencil to prevent paint bleed. At this point more toner came off; so I had to do some more repair.
The result:
I’m 100% happy with the blue phasers; they tend to not show up well on the black without a grey border. Not sure what if anything I’m going to do.