Stock Available in quantity
A pair of Extended Exit lane ball guides for William's Star Trek: The Next Generation Pinball machine in laser cut Stainless Steel. These are similar in design to the original ball guides except they add as much as 0.5 inches to the end of outlane to help "equalize" the ratio of ball drains into the outlane. Ball drains do occur; just less frequently. This 0.5 inches is measured from center of outlane post to the tip of the lane guide.
You will need to re-use the mounting hardware from your existing ball guides including the woodscrews, machine screws, spacers, and washers. We do not supply these.
Comes with a Left and a Right ball guide connected via a tiny "mouse bite" for shipping purposes.
Installation is straight-forward; but Step-By-Step installations Instructions are available here:
STNG Lane Install
and should only take you about an 0.5 hours to install.
Revision 4 increases the lamp hole sizes to increase the amount of light going to the lane plastics.
Available options:
- Mousebites
- No Mousebites - we remove them before shipping
Available Options:
Customize: