Low Stock available
This set of Printed-circuit Board Assemblies (PBA) come assembled with battery holder circuit board to power the NCC-1701's internal White LEDs along with two Red LEDs you'll install in the Nacelles.
Here's an Example Installation:
Preliminary Detailed Step-By-Step installations Instructions
This DIY kit is what I would call SUPER Advanced. It will probably take several nights or a weekend to wire up the Nacelles (If you choose to go that route).
For more information on these kits or for general help; please visit the Pinside Thread.
- One Set of NCC1701 PBAs
- 2 qty 5mm Red Nacelle LEDs
- 12inches of Enamel Wire
- 1 Aluminum #6-32x1/4"x5/8" stand off
- 1 Running Press Light-Up Starship Enterprise optional